/page.php / / content
Menu

Find Your Perfect Door:

Phone Call us On 0115 838 9905

Guarantee

We're confident in the quality of every door we sell, so all of them come with a long-term guarantee. Here's what's covered, how to look after your doors so your guarantee stays valid, and what to do if something goes wrong.

How long you're covered

Internal Doors and Joinery

  • Door leaves: 10 years
  • Hardware: 5 years
  • Framing: 5 years

External Timber Doors and Joinery

  • Manufacturing defects: 10 years
  • Glass units: 5 years
  • Hardware: 5 years
  • Factory-applied lacquer finish (clear or tinted): minimum 2 years
  • Factory-applied paint finish: minimum 2 years
  • Primed or unfinished doors: 2 years

Patio Doors (aluminium and uPVC)

  • Frames and hardware: 10 years
  • Glass units: 5 years

All guarantees depend on your doors being cared for and maintained as described below. Our finish guarantees are given in line with EN 927 parts 1 to 7.

What the guarantee includes

  • Your guarantee covers manufacturing faults. If a part turns out to be faulty, we'll replace it.
  • It covers replacement of the faulty part only, up to the value of that part. It doesn't cover other costs, such as fitting, labour or redecorating.
  • It applies to the original purchaser, so please keep your order confirmation or invoice as proof of purchase.
  • It covers products bought from us and delivered to addresses in the UK.
  • To keep your guarantee valid, please follow the storage, handling, fitting and care advice below.

This guarantee is in addition to your statutory rights. It doesn't affect your legal rights under the Consumer Rights Act 2015.

Timber is a natural material

Timber reacts to its surroundings, so it can swell or shrink slightly as humidity and temperature change. This is normal and isn't a defect. Natural variations in colour and grain aren't defects either. They're part of what makes every timber door unique.

Check before you start. Inspect every door for damage before you finish or hang it. If you spot a problem, please don't work on the door. Contact us first so we can help.

Before fitting: storage and acclimatisation

A little care before fitting makes a big difference.

  • Keep doors wrapped. Leave the protective wrapping on for as long as possible.
  • Store doors flat. Lay them on a level surface, raised on at least three level bearers that are longer than the doors. Space the bearers equally along the length of the door and make sure they run across its full width. Raising doors off the floor lets air circulate around them. Never stand doors on their edge or end.
  • Choose the right spot. Store doors in a dry, well-ventilated area, away from extremes of temperature or humidity.
  • Keep them out of daylight. Daylight can fade or discolour undecorated timber, so store unfinished doors away from it.
  • Let them settle. Leave doors in the room where they'll be fitted for 2 to 3 days before hanging. A cool, dry room is best.
  • Wait for wet trades to dry. Don't store or fit any door until plastering, rendering, cement work and concrete floors are finished and fully dried out, both inside and outside the building. This includes render around external door openings. Moisture from these wet trades can make doors swell, and can cause problems with veneers, joints, mould or movement. Without heating or extraction, plaster can take up to 7 days to dry.
  • Avoid sudden heat. Don't suddenly expose doors to central heating or other direct heat.

Handling

Doors can be heavy. Many weigh more than 15kg, and glazed doors almost always do. To avoid injury and damage, use two people or suitable lifting aids where needed. You'll find guidance on safe manual handling on the HSE website.

Hanging your door

This advice applies to both internal and external doors.

  • Trimming: if you need to trim a door, take an equal amount off each side and off the top and bottom. Every product has its own trimming tolerance, so check the fitting instructions supplied with your door. Trimming beyond that tolerance can weaken the door and may void your guarantee.
  • Locks: keep lock cut-outs as small as possible and away from the rail joints.
  • Oak doors: use stainless steel or galvanised fixings only. Mild steel can react with oak and leave black stains. For the same reason, keep steel wool and any steel or iron fragments away from untreated oak.

Internal doors and joinery guidance

Finishing and Decorating

  • Unfinished doors: fully decorate the door as soon as it's unpacked. Your coating supplier can advise on the best product.
    • Veneered doors: can be painted, stained, varnished or finished with a hardwax oil such as Osmo PolyX Oil or Treatex Wax Oil. Never use Danish Oil on veneered doors.
    • Paint-grade doors: decorate with a good-quality timber paint.
  • Primed doors: these come with a white primer coat, ready for painting. Decorate them straight after hanging, using a good-quality paint that's suitable for internal timber and complements your property.
  • Prefinished doors: these arrive fully finished and ready to hang. If you trim an edge or cut out for hinges, reseal the exposed timber straight away.
    • Veneered doors: reseal with Osmo PolyX Oil or Treatex Wax Oil. Never use Danish Oil on veneered doors.
    • Painted doors: touch up with a good-quality timber paint to match the door's finish.
  • Whatever the finish, keep doors away from damp or humid conditions, and don't hang or decorate them in a damp room.

External timber doors and joinery guidance

Hanging

  • Hinges: hang external doors on at least three 102mm hinges that are suitable for outdoor use.
  • Thresholds: we recommend fitting a weather threshold (such as a Stormguard) to stop rain getting underneath.
  • Exposed locations: for doors in exposed spots, we recommend a canopy or porch for extra protection.

Finishing Primed and Unfinished Doors

  • Seal or prime every surface as soon as the door is unwrapped and before it's fitted or exposed to the weather. This includes the top and bottom edges and every cut-out for locks, hinges and letterplates. No bare timber should be left untreated. Decorating before the door goes outside stops moisture in the air being trapped under the coating.
  • Make sure the door is clean, dry and dust-free first. Lightly sand away any handling marks with fine sandpaper. Never use steel wool.
  • Finish with a branded, high-build microporous paint or stain: at least one base coat and two top coats. Lightly sand between coats and allow plenty of drying time. Sikkens and Sadolin are proven systems, available from most DIY and decorating retailers.
  • Treat both sides of the door the same, and seal all surfaces at the same time so moisture can't build up unevenly and distort the door.
  • Doorsets: give the frame the same three-coat treatment as the door, including the back of the frame.
  • Softwood doors are designed to be painted, not stained.
  • Follow the paint or stain manufacturer's instructions and check their product suits your door's construction, timber and location. Some water-based finishes can react badly with veneered doors, so check with the manufacturer first.
  • Don't apply varnish, lacquer, wax, polish, oil or yacht varnish. These don't protect external doors well enough.
  • Choose a finish with good UV protection.
  • Avoid dark colours on doors that face south or partly south, as these get the most sun. Dark colours absorb heat, which can dry out the timber and make the door move.
  • Follow good decorating practice as set out in BS 6150:2019 (Painting of buildings) and BS 8000-12:1989 (Decorative wallcoverings and painting).
  • If a primed or unfinished external door isn't fully decorated before fitting, the guarantee won't apply.

Looking After Your Doors

  • Clean regularly: clean external doors inside and out at least every six months, using a mild detergent and a soft cloth. Never use anything abrasive.
  • Check the finish: inspect the finish at least every six months, and recoat before it starts to break down, in line with the paint or stain manufacturer's instructions. This applies to prefinished doors as well as doors you've decorated yourself. Doors in coastal or industrial areas need more frequent attention.
  • Fix damage fast: repair any chips or damage to the finish straight away so water can't get in. If the finish breaks down or moisture gets into the door, your guarantee will be void.

What isn't covered

  • Problems caused by incorrect storage, handling, fitting, finishing or maintenance.
  • If the finish is allowed to break down, or moisture gets into the door, your guarantee will be void. This applies to every part of the guarantee, including glass units and hardware. For example, if moisture makes a door swell and the swelling damages the hinges or lock, neither the door nor the hardware will be covered.
  • Shrinkage, warping and splitting on primed and unfinished external doors.
  • Natural variations in timber colour and grain.
  • Incidental costs, such as fitting, labour or redecoration.

Need to make a claim?

We're here to help. The quickest way to get things moving is our Aftersales Customer Support Form. Please include your order number and some photos of the problem.

You can also reach us by:

This guarantee is given by Vibrant Doors Ltd, Unit 2, Sinfin Central Business Park, Sinfin Lane, Derby, DE24 9HL.

Need More Information? Call us on 0115 838 9905 or send us an email
Why Choose Express Doors Direct?
All Prices Include VAT

With no hidden add-ons, all our prices on screen include VAT

10 Year Guarantee

Buy safe in the knowledge that all our products come with a 10 year guarantee as standard

3-7 Working Days Delivery*

With stock available to ship immediately, we can supply to your property in 3-7 working days. *Exceptions apply.

Safe & Secure Online Payment

We use Stripe to process our online transactions, one of the most trusted merchants in the industry.

Proud stockists of....

View All Brands

Heritage Steel-Look Industrial Style Doors

Bring industrial-inspired design into your home with our collection of heritage steel-look doors. Available in bifold, French and internal door options, these on-trend designs offer the distinctive appearance of traditional steel doors with the practicality of modern materials. Browse our range today and transform your living space with striking heritage style doors.

View Range

Trusted stockist of Climadoor; the Folding Doors brand.
© Express Doors Direct 2026. All rights reserved.
Company number 11557039.

Payment Logos

Rated 4.3 out of 5 by our customers from 1932 reviews.